国产乱码精品一区二区88av_日韩福利一级午夜_黄色在线观看视频免费_久久久无码精品亚洲日韩岛_天堂视频在线观看_都市激情亚洲一区_三级毛卡片免费看_免贵香蕉视频香蕉视频网站_精品国天心区卡一卡二在线_国产成人18亚洲精品在线乱码观看

Regarding the correct operation of the gas mold temperature machine, first of all, we actually should pay attention to it. Before using the gas mold temperature machine directly, it is actually necessary to check whether it has enough heat transfer medium ( Oil or water), whether there is pressure (that is, the pressure gauge should be zero), when it is abnormal, the machine cannot be forced to start, otherwise it will damage the machine, and in serious cases, it will cause a safety accident.

Next, for the connection of the gas mold temperature machine to the throat of the mold, in fact, it should be noted that it should be a direct use of a throat or a Teflon tube with a temperature resistance above 150 ℃. In terms of tubing, in fact, it should be noted that it should be connected and locked, and it should be noted that it should be checked again after booting to avoid loosening.

When the water source on the gas mold temperature machine and the surrounding environment of its cooling water tower are relatively harsh, the Y-type filter must be installed in the cooling water circuit, and timely cleaning should be carried out in time. In this regard, it is actually In other words, it will ensure the normal operation and operation of the cooling system of the mold temperature machine to a large extent.

For the power supply of the gas mold temperature machine, we actually need to pay attention to the fact that it should be used directly. The three-phase five-wire is used, and the voltage is actually 380V-400V. At this time, the mold temperature machine power supply is actually used. FireWire connects directly to a MCCB power switch. The neutral wire is actually connected to the neutral line (neutral wire), and its water line is connected to the power supply casing (ground wire).

Before the gas mold temperature machine is officially die-casted, we generally directly heat the mold surface. Just preheating the surface of the mold. At this time, in fact, it will be easier to cause the phenomenon of stress concentration, which damages the mold. It is precisely because of this that the gas mold temperature machine is actually before the gas heat mold. Start for at least half an hour.